Desa VDCFRNA - Manual (Page 25)

www.desatech.com 113133-01B 25
OPERATING FIREPLACE
Continued
OPTIONAL HAND-HELD
REMOTE OPERATION
Note: All remote control accessories must
be purchased separately (see Accessories,
page 40). Follow instructions included with
the remote control.
NOTICE: You must light the pilot
before using the hand-held re-
mote control unit. See Lighting
Instructions on page 23.
1. After lighting, let pilot flame burn for
about one minute. Turn control knob to
ON position. Adjust flame adjustment knob
anywhere between HI and LO. Slide the
selector switch to the REMOTE position
(see Figure 42). Note: The burner may light
if hand-held remote was on when selector
switch was last turned off. You can now
turn the burner on and off with the hand-
held remote control unit.
IMPORTANT: Do not leave the selector switch
in the REMOTE or ON position when the
pilot is not lit. This will drain the battery.
ON/OFF SERIES (MODEL [C]GHRCB)
Hold the control button on the hand-held remote
until burner turns on. Hold the control button
again until burner turns off (see Figure 43).
TO LOCK
press both buttons on hand-held
remote control until light stops flashing. Hand-
held remote control is now locked. If the fire is
on it will be turned off automatically. In the
locked state, the light will not light up when
any button is pressed.
TO UNLOCK
press both buttons together
on hand-held remote control until the light
stops flashing. The hand-held remote is now
unlocked.
THERMOSTAT SERIES (MODEL
[C]GHRCTB)
The hand-held remote can be operated using
either the manual mode (MANU) or thermo-
static mode (AUTO) (see Figure 44). To select
Fahrenheit/Centigrade mode display, carefully
press the ˚C/˚F mode button with the end of a
paper clip or similar blunt object.
Figure 42 - Setting the Selector Switch,
Control Knob and Flame Adjustment
Knob for Remote Operation
Flame
Adjustment Knob Control
Knob
Selector Switch in Remote
Position (Optional Remote Control)
Figure 43 - On/Off Hand-Held Remote
Control Unit (GHRCB)
Control Button
Turns Burners
On and Off
Figure 44 - Thermostat Hand-Held
Remote Control Unit ([C]GHRCTB)
Turns
Hand-Held
Remote On
or Off and
Allows You
to Choose
the Manual
Setting
Selects Auto
Setting
Increases
Room
Temperature
in AUTO
Mode
Digital
Display
Shows
Temperature
and Settings
Turns
Burners On
or Off
Decreases
Room
Temperature
in AUTO
Mode
Locks System to
Prevent Accidental
Ignition
Manual Mode
1. Press the POWER and LOCK buttons
together to turn on the hand-held remote
control.
2. Press the MANU button to turn on the
fireplace.
3. Press the POWER and LOCK buttons
together to turn off the fireplace.
Auto (Thermostatic) Mode
1. Press the POWER and LOCK buttons
together to turn on the hand-held remote
control.
2. Press AUTO button to select this mode.
3. Set the desired room temperature by press-
ing the TEMP + or - buttons.
4. Press the POWER and LOCK buttons
together to turn off the fireplace