BECKHOFF EL9800 Basisplatine - Manual (Page 32)

Altera Quartus II Programmer™
30 EL9800
3.3 Choosing the programming file
After successful conversion of the SOF-file, the programming of the EEPROM can take place. As shown
in Figure 22the EEPROM (EPCS16) has to be chosen. The programming file has then to be set by click-
ing on the button “Change File”.
Figure 22 Selection of the programming file
The last step is to configure the programming process, by setting check marks on “Program/Configure”
and “Verify”.
3.4 Programming of the FPGA/EEPROM
The programming process is then started by clicking on the button „Start“. In the message field the pro-
gramming process is logged. And in case of a faulty programming process an error message is displayed
in this field.