Bematech KC-4112 Rev.1.1 - Manual (Page 10)

User’s Manual
10
Unpacking
Take the printer out of its box and verify that the following items are included:
• Printer
• User´s Manual
Keep the box and packing materials for future use if necessary.
Paper roll is not included – the appropriate thermal paper should be used. Refer to the Technical
Specifications section in this manual for paper details.
Powering
Make sure that the printer is turned off. Connect the power cord
to the power supply‘s AC connector and to an electrical outlet.
This outlet must have its ground pin connected as shown on the
right:
Connect the DC cable of the power supply in the printer as shown below – note that the arrow in the
connector must be facing up:
Turn on the printer using the on / off switch located on the printer. Check, also in the panel, if the Power LED
is lit. If no paper is present, the Paper LED will also be lit.
Figure 4
Figure 5
Ground
DC connector