D-Link DGE-500SX User Manual

Page 11

Advertising
background image

10

LOAD C:\NWSERVER\NBI.NLM

LOAD C:\NWSERVER\MSM.NLM

LOAD C:\NWSERVER\ETHERTSM.NLM

LOAD C:\NWSERVER\DLKGE SLOT=1 FRAME=Ethernet_802.3

NAME=DLKGE_1_E83

BIND IPX DLKGE_1_E83 NET=xxxx

LOAD C:\NWSERVER\DLKGE SLOT=1 FRAME=Ethernet_802.2

NAME=DLKGE_1_E82

BIND IPX DLKGE_1_E82 NET=xxxx

LOAD C:\NWSERVER\DLKGE SLOT=1 FRAME=Ethernet_II

NAME=DLKGE_1_EII

BIND IPX DLKGE_1_EII NET=xxxx

LOAD C:\NWSERVER\DLKGE SLOT=1 FRAME=Ethernet_SNAP

NAME=DLKGE_1_ESP

BIND IPX DLKGE_1_ESP NET=xxxx

6. Restart the server again.

Parameters supported by the DLKGE.LAN driver

SLOT 1 – Forces the driver to search for the specified card.

FULLDUPLEX – The FULL-DUPLEX parameter causes the DLKGE to operate in full-duplex mode. When

operating in full-duplex mode, the DLKGE can simultaneously transmit and receive packets.

AUTONEGOTIATE – The AUTO-NEGOTIATE parameter causes the DLKGE to auto negotiate the duplex

mode and link speed with the device being connected.

TXDMATHRESHOLD – The TXDMATHERESHOLD determines the I/O method used to move transmit

packets from host memory to the DLKGE memory. The valid range for the TXDMATHRESHOLD is 0 -
1514. the default value is 800.

DISABLERXIP – Disables the DLKGE TCP/IP Receive Packet checksum support. By default, the DLKGE will

perform TCP/IP checksum verification on received packets in hardware if the operating system supports
this capability.

Due to the large number of Network Operating Systems (NOSs) supported, detailed driver

‡

software installation

instructions are given in README.TXT files on the DGE-500SX Software Diskette/CD-ROM. Review the root
directory README for overview information. For detailed installation instructions see the README and
referenced instruction files in the subdirectory corresponding to your network operating system.

‡

Check http://www.dlink.com periodically for driver upgrades.

Advertising