Besafe iZi Kid i-size - Manual (Page 5)

14 15
Positioning the child
1. Position of the shoulder straps: Check that the shoulder strap
slots are level with your child’s shoulders.
2. The height of the shoulder straps and the head rest can be
adjusted by pulling the release handle upwards at the back
of the head rest and pulling the head rest up or down while
keeping the head rest upright. (39)
3. Pull the shoulder straps up while pressing the button of the
central adjuster. (40)
4. Open the harness buckle.
5. Position the shoulder straps over the orange marking at
sides of the seat to keep the harness open while you position
the child. (41)
6. When the child is positioned, place the shoulder straps over
the child’s shoulders and close the buckle: CLICK! (42)
7. Pull the harness strap through the central adjuster in the
direction of the arrow straight up/forwards. Continue pulling
until the harness is a comfortable but firm fit. (43)
! Make sure that the harness straps are always locked and
tightened when the child is in the seat.
Sleeping position
• The seat has 3 positions.
• By pulling the recline lever upwards, the seat can be
adjusted into another position. (44)
• too high (37)
• correct (38)
• Do take care when you remove the cover, as fitting the cover
is done in reverse.
• Start taking off the lower seat part. (45)
• The cover of the head rest can be taken off separately by
disconnecting the hooks at the back and pulling off the
fabric towards the front.
• Pull the head rest in the highest position. Replace the head rest
cover and reconnect the hooks at the back side. Pull the harness
straps through the holes. Connect the loose lower part of the
head rest fabric with the plastic part below the head rest.
• Pull the harness straps through the opening of the seat cover
and lock the harness buckle. Pull the crotch strap through the
opening of the seat part.
• Refit the top part and then the shoulder parts. Refit the
seat part and bring the seat cover under the rear parts of
the sidewalls.
Removing and refitting the cover
Removing the cover
Refit the cover
Cleaning instructions
• The cover of the seat must be washed according to the
instructions on the inside of the cover.
• DO NOT use any aggressive cleaning products; these may
harm the construction material of the seat.