Besafe iZi Sleep - Manual (Page 6)

10 11
Removing from a stroller
Installation on a stroller
Using the iZi Sleep with a stroller
• The iZi Sleep can be installed on a range of strollers. For a
complete list check www.besafe.eu
(14)
(15)
(16)
1-
1-
2-
2-
Move the carrying handle into carrying position.
Align the stroller adapter house
above the adapters of the stroller
and move straight down, click (2x)
(14).
Move the carrying handle into
sleeping position (15).
Push the stroller release up at both sides while
lifting the seat vertically from the stroller (16).
click!
click!
Cleaning instructions
• The cover of the seat must be washed according to the
instructions on the inside of the cover (17).
• DO NOT use any aggressive cleaning agents; these may
harm the construction material of the seat.
wash with similar colours
(17)
Removing and refitting the cover
Removing the cover
Refit the cover
• Pay attention when you remove the cover, as fitting the cover
is done in the opposite way.
• Remove the headrest.
• Remove the upper cover. Detach the cover from the small
hooks on both sides of the back part. Release the rubber
bands that attach the cover to the inside of the back. Open
the zippers on both sides and detach the velcro. Pull the
cover from the seat plate.
• Remove the lower cover. Detach the elastic knots of the lower
cover. Pull the cover over the central adjuster. Detach the
elastics which attach the cover to the inside of the seat part
of the iZi Sleep.
• Refit the cover, using the removing instructions in reversed
order. Start by pulling the cover over the seat plate.
• Pull the harness straps through the openings in the cover and
close the zippers.