Dansons Group CC3 - Manual (Page 8)

Copyright 2005 8 Vulcan V SERIES Owner’s Manual
Canadian Comfort Industries www.stovesunlimited.com Dansons Group Inc.
S
PECIFICATIONS
HEATING SPECIFICATIONS
- Approx. Heating capacity (Sq Feet) ¹ = 800 – 2,000 sq ft
- Approx. Fuel burn rate per hour ¹¹ = 1.75 – 5.5 lbs per hour
- Hopper Capacity VULCAN “V” Series V130 = 55 pounds
- Hopper Capacity
VULCAN “V” Series V150
= 120 pounds
¹ Heating capacity will vary depending on floor plan layout of your home, degree of insulation, and the
outside temperature. Fuel size, quality, density and moisture level will also have an effect.
¹¹ Pellet size may affect the actual rate of fuel feed and burn times. Fuel feed rates may vary by as much as
20%. Use PFI listed fuel for best results.
DIMENSIONS
ELECTRICAL SPECIFICATIONS
Electrical Rating = 115 Volts 60 HZ 2.0 Amps
Watts (operational) = 175 (approximately)
Watts (optional igniter) = 475 (approximately)
A voltage surge protector or ground fault outlet is required for this unit. The warranty on the circuit board
will be voided if surge protection is not installed before operating this unit.
FUEL CONSIDERATIONS
Your VULCAN “V” Series shop and home heater, is designed to burn pellets that comply with Association of Pellet
Fuel Industries standards. (Minimum of 40lbs density per cubic ft, ¼ to 5/16’ diameter length no greater than 1.5”,
not less than 8,200 BTU’s/lb, moisture under 8% by weight, ash under 1% by weight, and salt under 300 parts per
million) Pellets that are soft, contain excessive amounts of loose sawdust, have been or are wet, produce clinkers
and/or heavy ash will result in reduced performance and may actually cause the fire to go out.
(see pelletheat.org for further information)
EPA COMPLIANCE
This heater is exempt from EPA Phase II requirements, but has been tested for emissions using EPA test methods
by Warnock Hersey , US. Pellet appliances that are designed with the combustion air supply exceeding 35:1 (by
ratio) are exempt from EPA regulations.
PRODUCT IS SUBJECT TO CHANGE WITHOUT NOTICE.
+
+
8 1/4”
14 1/4”
3 3/4”
26”
23”
28”
8 3/4”
24”
31 1/2”
“V” Series V-130 “V” Series V-150
Exhaust
Air Inlet
+
+
7”
9 1/4”
12 ½”
5 ½”
3” Dia.
Exhaust
2”
Air Inlet
22”