Denon AVR-2309 - Manual (Page 7)

• Before turning the power switch on
Check once again that all connections are correct and that there are
no problems with the connection cables.
• Power is supplied to some of the circuitry even when the unit is
set to the standby mode. When traveling or leaving home for long
periods of time, be sure to unplug the power cord from the power
outlet.
• About condensation
If there is a major difference in temperature between the inside of
the unit and the surroundings, condensation (dew) may form on
the operating parts inside the unit, causing the unit not to operate
properly.
If this happens, let the unit sit for an hour or two with the power
turned off and wait until there is little difference in temperature
before using the unit.
• Cautions on using mobile phones
Using a mobile phone near this unit may result in noise. If so, move
the mobile phone away from this unit when it is in use.
• Moving the unit
Turn off the power and unplug the power cord from the power
outlet.
Next, disconnect the connection cables to other system units before
moving the unit.
• Note that the illustrations in these instructions may differ from the
actual unit for explanation purposes.
Cautions on Handling
Note:
For proper heat dispersal, do not install this unit in a confined
space, such as a bookcase or similar enclosure.
b Note
b
Wall
b
b
Cautions on Installation
In addition to the AVR-2309, the included remote control unit (RC-
1099) can also be used to operate the equipment listed below.
q
DENON system components
w Non-DENON system components
• By setting the preset memory (vpage 56 ~ 58)
About the Remote Control Unit
Get
ting Star
ted
Check that the following parts are supplied with the product.
q Owner’s manual ...................................................................... 1
w Getting Started ........................................................................ 1
e Service station list ................................................................... 1
r Power cord (Cord length: Approx. 1.6 m) ................................ 1
t Remote control (RC-1099) ....................................................... 1
y R6/AA batteries ....................................................................... 2
u FM indoor antenna .................................................................. 1
i AM loop antenna ..................................................................... 1
o Setup microphone
(DM-A409, Cord length: Approx. 7.6 m) .................................. 1
r t o u i
Thank you for purchasing this DENON product. To ensure proper
operation, please read these owner’s manual carefully before using
the product.
After reading them, be sure to keep them for future reference.
Getting Started
Accessories
q Lift the clasp and remove the rear lid.
e Put the rear cover back on.
R6/AA
w Load the two batteries properly as indicated
by the marks in the battery compartment.
Inserting the Batteries
NOTE
• Replace the batteries with new ones if the set does not operate
even when the remote control unit is operated close to the unit.
• The supplied batteries are only for verifying operation.
• When inserting the batteries, be sure to do so in the proper direction,
following the “q” and “w” marks in the battery compartment.
• To prevent damage or leakage of battery fluid:
• Do not use a new battery together with an old one.
• Do not use two different types of batteries.
• Do not attempt to charge dry batteries.
• Do not short-circuit, disassemble, heat or dispose of batteries in
flames.
• If the battery fluid should leak, carefully wipe the fluid off the inside
of the battery compartment and insert new batteries.
• Remove the batteries from the remote control unit if it will not be in
use for long periods.
• When replacing the batteries, have the new batteries ready and
insert them as quickly as possible.

Connections
Set
up
Pla
ybac
k
Remot
e Contr
ol
Multi-z
one
Inf
or
mation
Tr
oubleshooting
ENGLISH
Specifications