Beurer HDE 15 - Manual (Page 13)

12 13
note
A slight odour initially develops after switching
on the device for the first time. This is normal
and not harmful to your health. Allow the device
to run for three to five minutes. After that you
can use the device as normal.
• For your safety, the device switches off auto-
matically if it overheats.
• Pull the mains plug out of the socket and
allow the device to cool down.
• Before switching the device back on, check
the protective grille with lint filter [8] for any
blockages.
• Switch on the travel hair dryer at the sliding
switch [7]:
0 Off
1 Low air flow, warm air
2 High air flow, hot air
• You can use the rotating professional nozzle
[1] to adjust the direction of the hot air as
required.
• Dry and/or style your hair as desired.
• The cold level offers the perfect styling finish.
It cools down your hair and holds it in place
for a better result. You can enable the cold le-
vel at any time by holding down the button. As
soon as you release the button, the previously
selected heat level returns.
• After each use/at each break, always switch
off the travel hair dryer at the sliding switch [7]
(setting 0).
• After each use, pull the mains plug out of the
socket.
• Allow the device to cool down.
• Do not wind the mains cable around the
device!
• Store the device in a dry place out of the
reach of children.
• The device can be hung on a hook using the
hanging eyelet [4].
7. Cleaning and care of the unit
notes
• Your device is maintenance-free.
• Protect the device from dust, dirt and humidity.
Cleaning
Important
• Always pull the mains plug out of the socket
before cleaning the device.
• Ensure that no water gets inside the device!
• Do not clean the device in the dishwasher.
• Do not use any aggressive, caustic, abrasive,
or corrosive cleaning products or hard bru-
shes.
• Do not clean the device with highly flammable
liquids!
• The casing of the travel hair dryer and the
professional nozzle [1] may be cleaned with a
soft cloth dampened with warm water.
• Before each use, remove any fluff and hairs
from the filter using an appropriately sized
brush.