Beurer HDE 30 - Manual (Page 14)

14
6. Operation
Important
• Do not jam the mains cable [8] e.g. in a drawer or door.
• Straighten the mains cable [8] if it becomes twisted.
• Do not pull, twist or kink the mains cable [8]; do not pull or lay it across/on sharp, pointy objects or
hot surfaces.
Warning
• Stand on a dry, electrically non-conductive surface.
• Ensure that your hands are dry!
• Dry your hair beforehand with a towel.
• Depending on the switch setting and duration of use, the volume diffuser [1], professional nozzle
[9] and hair dryer can become very hot – burn and fire hazard!
• Do not touch the volume diffuser [1] and the professional nozzle [9].
• Let the volume diffuser [1] and professional nozzle [9] cool down first before you remove them.
• Place the hair dryer only on a non combustible surface.
• Ensure that there are no highly flammable liquids in the vicinity of the unit.
• Do not use the unit on artificial hair – fire hazard!
• Ensure that no hair can be directly sucked in.
Note
After switching on the unit for the first time, a light odour develops for the first minutes. This is
normal and not hazardous to your health. Let the unit run for three to five minutes. Then you can use
the unit normally.
• If the unit becomes overheated, it switches off automatically for your safety.
• Remove the plug from the socket and let the unit cool down.
• Before switching the unit on again, check the air outlet [2] and the filter [3] for blockage (e.g.
sucked-in lint, dust, hair).
• Switch on the travel hair dryer via the slide switch [6.1]:
Strong airflow
Gentle airflow
• Select the heat level:
High temperature
Medium temperature
Low temperature
• Dry and/or style your hair as you wish.
After each use/interruption, always set the hair dryer slide switch [6.1] to off (position 0).