Beurer HTE 50 - Manual (Page 24)

24
Cleaning the straightening/crimping iron
[F/G]
• Slide the selector switch [11] into the
"Straighten" position [a].
• Press on the lever [3] to open the
straightening/crimping attachment [12].
• Use the fingers on your other hand to slide
the selector switch [11] into the "Crimp"
position [c]. Now the straightening/crimping
iron [F, G] is unlocked.
• Remove the straightening/crimping iron
[F, G] from the straightening/crimping
attachment [12].
• Now the straightening/crimping iron [F, G]
can be cleaned, like the other attachments.
• Attach the straightening/crimping iron [F, G]
again after cleaning it. Attach it by following
the removal steps in reverse order.
8 Technical specifications
Weight Approx. 330 g
Power supply 220 - 240 V ~, 50 Hz
Power consumption 25 W
Temperature range 125 to 160 °C
Safety class II
Ambient conditions Only approved for indoor use
Allowable temperature range -10 to +40 °C
Subject to technical modifications.
9 Disposal
In the interest of protecting the environment,
the unit must not be thrown out with the
household waste at the end of its service life.
Dispose of the unit at a suitable local
collection or recycling point.
Observe the local regulations for
material disposal.
Dispose of the unit in accordance with
EC Directive 2002/96/EC–WEEE (Waste
Electrical and Electronic Equipment).
If you have any questions, please contact the
local authorities responsible for waste
disposal.
You can find out about collection points for
your old units e.g. from the local municipal
government, the local waste disposal
company or your dealer.