Beurer LB 12 - Manual (Page 12)

12
• By turning the control dial to the right, you can adjust the nebulisation performance between “MIN”
and “MAX”.
• Through operation, the device and the water in the base warm up.
• To switch the air humidifier on again, turn the control dial to the left.
• Device automatically switches off if the water runs out.
• Switch off the device when refilling the bottle with water. Change the water in the bottle every day so
that fresh water is always taken in.
• Switch off the device and pull out the plug when you are not using the air humidifier.
• Empty any remaining water when the device is not in use.
6. Cleaning, maintenance and storage
Weekly cleaning and disinfection is a requirement for fault-free and hygienic operation.
WARNING
Switch off the air humidifier each time before cleaning. Pull the plug out of the mains socket.
IMPORTANT
• Never submerge the base in water.
• Important! Empty the water from the base unit via the side rim. Ensure that no water gets inside
the device, e.g. via the air outlet or the control dial.
• Completely clean the bottle and the air humidifier if the device has not been used for over three
days.
• Clean the device using only the methods specified.
• Do not use any solvent-based cleaning products.
• Use only a mild detergent or vinegar/vinegar-based cleaner to perform cleaning or disinfection
work.
Clean all parts that come into contact with water on a weekly basis. Let the device cool down for ap-
prox. 60 minutes.
Completely remove the mist outlet, then remove the top in an upward direction.
• Make sure that the ultrasonic membrane always remains free from limescale so as to ensure a long
service life. Always use the cleaning brush for this purpose and apply standard descaling agents. Leave
the descaling agent to work for as long as is required to dissolve all the limescale and dirt deposits. To
avoid damaging the ultrasonic membrane, never scrape with sharp, hard objects. Rinse out the base
if necessary.
• Wipe the interior of the base with a cloth. Use a mild cleaning product. Rinse out the base if
necessary.
• Wipe the exterior housing of the base with a damp cloth.
• Clean all removable parts, such as the bottle, bottle adapter, mist outlet and top, with a mild detergent
or vinegar/vinegar-based cleaner. Clean the parts thoroughly, particularly the bottle.
• Bottle adapter, mist outlet and top are dishwasher-safe.
Dry the parts with a soft cloth and only reassemble them when they are completely dry.
For storage and easy transport, e.g. for travel, a storage pouch is available.