Blu Bathworks BCT060 - Manual (Page 2)

Attention — Before Installation
Thank you for choosing from among Blu’s quality line of products. We recommend that you carefully read this installation
guide to ensure your unit’s proper operation and reliability for many years to come.
Installation Requirements
Please read the instructions carefully so as to avoid any damage to the fixture.
1. To ensure this product is installed properly, you must read and follow these guidelines.
2. The owner/user of the product must keep this information for future reference.
3. Consult local building codes to make sure the installation complies with standards.
4. Remove the unit from its packaging. Before disposing of it, inspect the unit to make sure its in good shape. Should
inspection reveal any damage or defect in the finish, contact your distributor. The warranty does not cover damages or
defects in the finish once it has been installed. Blu Bathworks’ responsibility for shipping damages ceases upon delivery
of the product in good order to the carrier. All complaints regarding damage due to transport must be made directly to
the carrier.
5. Place the unit in the bathroom before you start working. Conserve all nuts and bolts.
6. To protect the unit during installation, we recommend that you lay a piece of cardboard on the bottom.
7. If the unit is covered with polyethylene protective film, do not remove until installation is complete to grant maximum
protection. However, remove film where any two surfaces will be in permanent contact.
8. Verify that all dimensions on the plan are the same as the ones of the unit.
Installation Notes
Important! Install this product according to the installation guide.
Tools Required:
Technical Support Assistance
If further assistance is required, please contact:
Product Support at 1.866.907.0122 (09:00 – 17:00hrs PST) or email [email protected]
North America
Blu Bathworks Inc.
188 Smithe Street,Vancouver, BC, Canada, V6B 6A9
T +1.604.299.0122 F +1.604.299.0125
1 866 907 0122 blubathworks.com
2014-03
®
1
phillips screwdriver level
S
only neutral NON-Acetic Silicone