Installation for integrated basins – Blu Bathworks SA0600 User Manual
Page 3
2
1 866 907 0122 blubathworks.com
2014-01
®
Installation Notes
Important!
Install this product according to the installation guide. Product does have an overflow. Deck mounted faucet
spouts must provide a minimum of 5” reach for adequate clearance into basin, or a minimum 7½” reach for wall mounted
faucet spouts. Our products must be installed by certified professionals only and according to our installation guide as
well as federal, provincial / state and local building codes and regulations.
Installation for Integrated Basins
BASIN INSTALLATION
*Note: For deck mounted tapware refer to drilling instructions prior to the installation of the basin.
1. Apply a ¼” (6mm) continuous bead of silicone sealant around the top of the vanity, as illustrated.
2. Position the basin on top of the vanity.
3. Verify that the basin is level. If the basin is not level, gently press down on the basin.
4. Wipe away excess silicone sealant.
5. Allow the silicone sealant to set according to the sealant manufacturer’s instructions.
6. Complete the water supply and drain connections.
7. Run water into the basin and check for leaks.
Basin
Vanity
Apply a ¼” (6mm)
continuous bead of
silicone sealant around
the top of the vanity