Blu Bathworks SA0504 - Manual (Page 3)

2
1 866 907 0122 blubathworks.com
2015-02
Installation for Freestanding Basins
PREPARATION
1. Place pedestal into installed position. Ensure product is level when placed and mounting holes are located at the
sides.
2. Carefully mark the mounting hole locations for the pedestal onto the floor with a non-permanent marker.
3. To help recall the pedestal position, trace a line along the base of the pedestal.
4. Carefully remove the pedestal.
PEDESTAL INSTALLATION
5. Drill pilot holes for the floor mounting brackets 1⁄2” (12mm) inside the line.
6. Install the pedestal mounting hardware provided. Place a metal washer onto the bolts and insert the bolts through the
mounting brackets into the floor securely. Fig 1.
7. Return the pedestal into position with the mark on the floor.
8. Install the pedestal bracket to floor using the two supplied screws. Fig 2.
WARNING: DO NOT OVERTIGHTEN. Overtightening may damage the products and cause personal injury and/or
property damage.
Line of basin
Floor mounting
brackets
11"
Rear
cut-out
for drain
Min 2" (51mm)
Max 3” (76mm)
from finished wall
¾" Mounting holes
1
2
All dimensions based on
recommended 3” gap between
finished wall – actual distance
based on spout length to be
confirmed by installer
½"
(12mm)
1½"
(35mm)
ؼ"
Ø(8mm)