Blu Bathworks TSP100 - Manual (Page 3)

2014-01
1 866 907 0122 blubathworks.com
®
2
Installation Procedure for Single Hole
Refer to illustration 1
1. Remove the locking nut and rubber washer from the brass base of the mixer.
2. Place mixer body with its escutcheon ring and o-ring still attached through the faucet hole of the mounting surface.
3. From below the mounting surface, slide the rubber washer onto the brass base so that it presses up against the
mounting surface.
4. Screw the locking bolt onto the brass base by hand until tight and then turn an additional 1 /
4
turn using a wrench. Be
careful not to over tighten the bolt, as this may cause damage to the mounting surface.
5. Attach the supply lines to the water supply.
1
13 12
10
8
7
9
6
11
3
2
1