Brinly SA-400 BH Spike Aerator - Manual (Page 4)

1008590BH-C 4.
ASSEMBLY
================================================================================================
1. Install Drawbar (3) to the Tray (5) using two 5/16" X
1" Round Head Screws (11), two 5/16" Lock Washers
(13), and two 5/16" Hex Nuts (12) as shown in Figure
1.
2. Assemble the Clevis Drawbar (20) to the Drawbar (3)
using two 5/16" X 1" Round Head Screws (11), two
5/16" Lock Washers (13), and two 5/16" Hex Nuts
(12). See Figure 1.
NOTE: Install Clevis (20) in direction shown. 11
5
12
13
12
13
11
20
3
3. Install the two End Panels (1) to the Tray (5) using six
5/16" X 3/4" Round Head Screws (10), six 5/16" Flat
Washers (14), six 5/16" Lock Washers (13), and six
5/16" Hex Nuts (12). See Figure 2.
NOTE: Leave nuts loose in this step so that the
End Panels can be adjusted later.
12
13
14
10
10
14
14
13
13
12
12 1
5
1
2
15
15
1
19
17
4. Fasten an E Ring (19) onto the Tine Shaft (2) and
place a 5/8" Flat Washer (15) onto the Tine Shaft,
see Figure 3. Push the shaft through one End Panel
(1).
5. Place a Square Bearing (17) and then a 5/8" Flat
Washer (15) onto the Tine Shaft, see Figure 3.
Figure 3
Figure 2
Figure 1