Brinly DTZ-48 BH ZTR Front-Mount Dethatcher - Manual (Page 10)

1009719 Rev E 10.
Figure 10.
1-SETTING THE DETHATCH HEIGHT:
‡7RVHWWKHWLQHKHLJKWVHOHFWDVPRRWKIODWVXUIDFHVXFKDVD 
GULYHZD\VLGHZDONRUJDUDJHIORRU
‡3ODFHD´VKLPERDUGWRVXSSRUWWKHIURQWDQGEDFNURZRI
WLQHVDVVKRZQWKHZKHHOVPXVWEHRQWKHIODWVXUIDFH
‡8VHWKHVORWVLQWKHIUDPHEUDFNHW  WRKHOSOHYHOWKH
GHWKDWFKHU
‡%HVXUHWKHWLQHVDUHUHVWLQJRQWKHERDUGDQGWLJKWHQWKH´
[³FDUULDJHEROWV  DQG´KH[QXWV  IURP)LJXUH
‡$IWHUVWHSEHVXUHERWKPRXQWV  DUHOHYHOZLWKWKHJURXQG
DQGWLJKWHQERWKVHWVFUHZV 
 


6ORW
6(77,1*7+(6&$5,)<+(,*+7
‡7RVHWWKHWLQHKHLJKWVHOHFWDVPRRWKIODWVXUIDFHVXFKDVD 
GULYHZD\VLGHZDONRUJDUDJHIORRU
‡8VHWKHVORWVLQWKHIUDPHEUDFNHW  WRKHOSOHYHOWKHGHWKDWFKHU
‡%HVXUHWKHWLQHVDUHUHVWLQJRQWKHVPRRWKVXUIDFHDQGWLJKWHQ
WKH´[³FDUULDJHEROWV  DQG´KH[QXWV  IURP
)LJXUH
‡$IWHUVWHSEHVXUHERWKPRXQWV  DUHOHYHOZLWKWKHJURXQG
DQGWLJKWHQERWKVHWVFUHZV 
The dethatcher can be used in two ways
To set up for dethatching grass see step 1
To scarify the ground see step 2
1/2” Shim board Flat surface
Set screw
Figure 11.
Clevis Pin 5/16” x 1-3/8”
Qty. 2
34
34
Pivot pin holes
Transport position
holes
Dethatcher in transport position
Hairpin Cotter, .08"
Qty. 2
36
To set the dethatcher into transport mode remove both 5/16” x 1-3/8” clevis
pins (34) from both the pivot brackets (15) and (18).
Rotate the dethatcher up as shown and replace both 5/16” x 1-3/8” clevis pins
(34) into the next higher set of transport holes in the pivot brackets (15) and
(18) and secure with hair pin cotter (36).
15
18
OPERATION
================================================================================================