Daewoo DUB-2850GB - Manual (Page 9)

ON/OFF
The first time the TV set is powered ON, INSTALL menu will pop on screen. If you don’t want to install channels later press the key “MENU” twice to close all
menus. Otherwise from this menu you can start an automatic channel installation. See on page 10 how to start automatic installation.
7
DAILY USE
1) If stand-by indicator (B2) is red, then the TV set is in
stand-by mode.
You can switch on using the remote control POWER
button (A1), the NUMBER 0….9 buttons (A6), or
PROGRAM UP (A10) / DOWN (A10) buttons.
The front panel PROGRAM UP/DOWN buttons (B4 or
B5) can also be used.
Once on, the stand-by indicator turns to green and
the picture appears on the screen.
2) If stand-by indicator (B2) is not lit, then the TV
set is powered off.
You must press the TV set front panel MAIN
POWER button (B1).
If a picture does not appear, then the stand-by
indicator will be red.
In this case, use the remote control as
indicated in 1).
3) If stand-by indicator (B2) is flashing red, and
green then the TV set is in child-lock mode. It
is necessary to use the remote control POWER
button (A1), NUMBER 0….9 buttons (A6), or
PROGRAM UP (A10) / DOWN (A10) buttons.
The front panel PROGRAM UP/DOWN buttons
(B4 or B5) will not function.
Once on, the stand-by indicator turns to green
and the picture appears on the screen.
SWITCHING ON TV SET
SWITCHING OFF TV SET
1) Pressing the remote control POWER button
(A1), you can switch off to stand-by mode
(low power consumption mode) which also
allows quick restart by remote control
(see above: SWITCHING ON TV SET).
2) Pressing the TV set front panel MAIN POWER
button (B1), you can completely power off the
TV set.
In this case, you must use the same front
panel POWER button (B1) to switch on again
(see above: SWITCHING ON TV SET).
Remark: If an analogue broadcast signal is not present after 30 minutes, the TV set will automatically return to stand-by mode.
DIGITAL or ANALOGUE CHANNELS ?
This TV set can tune digital and analogue channels.
Use D/A button (A14) on the remote control to switch the TV between analogue and digital mode. Then use
▲PR▼ or 0..9 buttons to select channel.