BSS Audio DPR-504 Owner's Manual - Manual (Page 5)

5
Unpacking
2.0 Unpacking
As part of the BSS system of quality control, we check every product carefully
before packing to ensure that it reaches you in flawless condition.
Before you go any further, please check the unit for any physical damage and
retain the shipping carton and all relevant packing materials for use, should
the unit need returning.
In the event that damage has occurred, please notify your dealer
immediately, so that a written claim to cover the damages can be initiated.
Check out section 9.0 for more info on the warranty, and also to record your
dealer details.
3.0 Mechanical installation
A vertical rack space of 1U (1 3/4"/44.5mm high) is required, with a depth of
220mm, excluding connectors. Ventilation gaps are unnecessary.
If the unit is likely to undergo extreme vibration through extensive road
trucking and touring, the unit must be supported at the rear and/or sides to
lessen the stress on the front mounting flange. The necessary support can
generally be bought ready-built, as a rack tray, or the DPR 504 can be
mounted between other units. Damage caused by insufficient support is not
covered by the warranty. To prevent cosmetic damage to the front panel paint
finish, always use protective plastic cups under the rack mounting bolts.
As with any low-level signal processing electronics, it is best to avoid
mounting the DPR 504 next to a strong source of magnetic radiation or heat,
for example, a high power amplifier. The internal power supply regulators are
mounted on the case sides and use this as their heatsink. After a period of
time in an enclosure, the metal case will feel hot to the touch, but this is
quite normal and should not be cause for alarm.
Fig 3.1 Unit dimensions.
Mechanical Installation