Campomatic WM80K - Manual (Page 20)

20
HOW TO CLEAN THE FILTER
Cleaning the water inlet filter
• Clean the filter when water leaks from the water inlet.
Cleaning the drain filter
• This drain filter is used to screen the foreign stuffs such as threads, coins, pins, buttons etc..
• If the drain filter is not cleaned at proper time(every 10 times of use), drain problem could be
caused.
CAUTION : Be careful when draining if the water is hot.
Cleaning the detergent case
*After a while detergent and fabric softeners leave a deposit in the case;
- It should be cleaned from time to time with a jet of running water.
- If necessary it can be removed completely from the machine by pressing the catch downwards
and by pulling it out.
- To facilitate cleaning, the upper part of the fabric softener compartment can be removed.
*Detergent can also accumulate inside the recess which should be
cleaned occasionally with a brush.
*Once you have finished cleaning, replace the case and run a rinse
cycle without laundry.
1 Pull the power
plug out before
cleaning it.
2 Turn off the water
supply to the
washer and
separate the inlet
hose.
3 Pull the inlet filter
out.
4 Remove the dirt
from the inlet filter
with a brush.
1. Open the lower cover( 1) by
using a coin. Turn the cap
hose(
2) to pull out the hose.
Pull out the hose maximally.
(About 13~14cm.)
2. Unplug the cap hose( 2), allowing
the water to flow out. At this time
use a vessel to prevent water
flowing on to the floor. When water
does not flow any more, turn the
pump filter(
3) open to the left.
3. Remove any foreign material
from the pump filter( 3). After
cleaning, turn the pump filter
clockwise and insert the cap
hose(
2) to the original place.
Close the lower cover.
1
100
2 3
about
13~14cm
2
3
about
13~14cm