Caple DD900 - Manual (Page 12)

12
5/ OPERATIONAL ANOMALIES
SYMPTOM SOLUTION
The hood does not
work...
Check that:
• There is not a power outage.
• A specific speed has actually been selected.
• The panel is hung properly.
• The 9 pole connection is inserted properly.
• The red reset key, found over the electric system box, is pushed.
• Make sure that the wires are inserted properly in the 9 pole con-
nection, in the connector itself. (During the connection phase, an
excessive pressure could bend the contacts.)
The hood has low
output...
Check that:
• The motor speed selected is sufficient for the quantity of fumes
steam present.
• The kitchen is ventilated well enough to allow for air intake.
• The charcoal filter is not worn (filtering version cooker hood).
• The air outlet channel is free and compliant with paragraph 2.
• The non-return valves of the suctioning unit are free to rotate.
The hood stops in
the middle of ope-
ration.
Check that:
• There is not a power outage.
• The omnipolar device has not tripped.
The downdraft is
not perfectly in line
with the kitchen
range support sur-
face.
Adjust the position of the body edge , by shifting the “L” brackets po-
sitioned in the short sides of the lower body (Fig.24); in order to do it,
lift the downdraft, loosen the screws, change the position until perfect
linearity of the edge is reached , then tighten the screws and put the
downdraft again inside the cabinet.
Any maintenance on your equipment should be undertaken by:
- Either your dealer,
- Or another qualified mechanic who is an authorized agent for the brand appliances.
When calling, please mention the appliance details (Type Fig. 23a and equipment Fig. 23b and
production date Fig. 23c).
This information is mentioned on the rating label and the production date one placed on the
lower side of the downdraft.
6/ AFTER SALES SERVICE