Caple RFF60 - Manual (Page 5)

Preparation before Using
Transportation and placement of the fridge
Keep the appliance upright and avoid squeezing or vibration during transporta-
tion. Avoid a slant angle over 45 degree during handling.
Avoid the door or top cap from being under excessive stress when moving
otherwise, it may become deformed
Transportation
The fridge should be placed in a well ventilated place. Far away from any heat
source, also keep it out of direct sunlight. Do not place the appliance in a wet or
moist area, this is to avoid corrosion and weakening of the insulation.
Placement
There should be a space not less than 30cm from the top of your refrigerator and
not less than 10cm from both sides and the back of the refrigerator to the
adjacent
walls respectively. This requirement is to allow for the door to open fully and
also for the required heat emission.
The fridge should be placed on flat, solid ground (if uneven, it can be adjusted by
the leveling legs)
Make sure the power wire is not damaged or trapped by the refrigerator or
other
objects so as to avoid accidents arising from power wire faults. Please check
the voltage scope of your refrigerator against the actual power supply before
switching it on.
NOTE:
Ensure the fridge is correctly installed and you understand all the safety precautions
before use.
The appliance will automatically enter the factory settings once plugged in and
switched on. The temperatures can be adjusted as shown on pages 5 to 7.
1.Connect to the power supply
Correct Use of the Fridge
Artificial Intelligence... This fridge freezer is equipped with a computer control
which automatically adapts to changes in the ambient temperature keeping the
storage temperature consistent.
2.Fridge modes
Intelligent mode: We suggest you use this setting if you have no special require-
ment. This will allow the fridge and freezer settings to be automatically
controlled by the internal computer.
Power saving mode: If you are going on holiday or have very little food to store
you can use this setting. The appliance will run using less energy.
Manual mode: you can adjust the temperature of each storage chamber accord-
ing to your need.
3