Dynex DX-E102 - Manual (Page 6)

6 DX-E102
2 Click Install Driver to start the installation wizard.
3 Click Next, then Finish when the wizard is complete.
4 Click EXIT to close the Dynex PCI Adapter window.
Using Wake On LAN
Your DX-E102 features Wake On LAN (WOL). This feature lets a remote computer “wake” your
computer when it is in Standby or Hibernate mode.
For more information about WOL, see your user guide.
Note: The WOL feature is system dependent. In addition to the following instructions, you
may need to download WOL software from Intel or another manufacturer’s Web site. See
your computer’s user guide for specific BIOS settings.
To enable WOL:
1 Turn on your computer and press Delete or F1 when prompted to enter the BIOS
Setup utility. The keys you press to enter the BIOS Setup utility may vary, so see your
computer’s user guide for more information.
2 Enable the WOL feature or power-on feature of the computer. The name of this feature
depends on the system, but it may be located in a category such as “Power
Management.” See your computer’s user guide for more information regarding the
BIOS Setup utility and BIOS settings.
Note: The LED on your DX-E102 will turn off when your computer is shut down, even when
WOL is enabled.
DX-E102-ENG.fm Page 6 Tuesday, October 20, 2009 7:43 PM