Caple WMF1020 - Manual (Page 6)

33
The water supply hose is inside the drum:
a Connect the bent end of the hose to the
threaded inlet of the electrovalve located
at the rear of the washing machine.
b Connect the other end of the hose to the
water intake. Then securely tighten the
connection nut.
It is important that the drain hose bend
is correctly fastened to the outlet, to
prevent any risk of it becoming
detached and causing flooding.
If your washing machine has a hot
water intake, connect the hose with
the red threaded end to the hot water
tap, and to the electrovalve with the
red filter.
The washing machine must be
connected to the mains water supply,
using the new supply hoses supplied
with the appliance. Do not use water
supply hoses that have been used
before. For your washing machine to
work properly, the mains water
pressure must be between 0.05 and
1MPa (0.05 and 10 Kgr/cm
2 ).
a It is recommended that you have a fixed
drainage outlet 50 to 70 cm from the
floor.
Avoid the drain hose being too tight,
kinked or restricted. Use the bend
supplied.
Important
CONNECTION TO THE MAINS WATER SUPPLY AND
DRAINAGE
installation and assembly
2
CONNECTION TO THE
MAINS WATER SUPPLY
DRAINAGE
CONNECTION