Dual XDVD270 - Manual (Page 11)

XDVD270 OPERATION
Quick-Start Guide
11
Slide the OPEN button to the right and gently lift the lid.
The lid opens to a maximum 90 degrees. Do not open it any
further - as severe damage to the unit may occur.
Align the center of the disc with the center of the spindle
guide. Press gently down on the center of the disc to snap it
into place, then gently close the lid until a click is heard.
Press the POWER button on the main unit for more than 2
seconds to turn the unit on.
Press the PLAY button. In general, the DVD will start playing
automatically when the power is turned on. The DVD player
will immediately start rendering the DVD program.
“ “ may appear on the display during operation.
“ “ means that feature or operation is not permitted by the
DVD player at this time.
Press the STOP button momentarily. The unit will return to
the start-up logo.
When the unit is on, press POWER for more than 2 seconds
to turn the unit off.
The unit will automatically enter screen saver mode
(if activated) after approximately 3-1/2 minutes of no
activity. The unit will also automatically power off after
approximately 10 minutes of no activity.
Note:
The unit will resume playback from the beginning of the
DVD when
POWER is turned on.
Remove the clear plastic separator from the battery
compartment before using the remote control. When
replacing the battery, use only a 3 volt Lithium CR2025 or
equivalent.
Point the remote at the IR sensor located on the front of the
main unit. The operating distance is up to 20’ away from the
main unit within 30° of the IR sensor.
Inserting a Disc
Power On
Playback Start
Playback Stop
Power Off
Automatic Power Off
Using the Remote Control