Dynex DX-OP7CC - Manual (Page 3)

Specifications 3
Reversing the shredder
If too many papers are inserted, the shredder will stop, and you must
reverse the shredder to back out the jammed paper.
To reverse the shredder:
• Push the switch to REV. The cutters go into reverse, and the
jammed paper is ejected from the shredder.
Emptying the waste basket
You should empty the waste basket as soon as it gets full, or the shredder
may become jammed with paper scraps.
Caution: Do not pack the shredded paper into the basket to avoid
emptying it. Do not kick or drop the basket.
To empty the waste basket:
1 Check the clear window on the front of the waste basket to make
sure the basket is full, then remove the shredder unit from the
waste basket.
Tip: To make it easier to remove the shredder unit, grasp the handles on the
waste basket while lifting the shredder unit away from the basket.
2 Empty the wastebasket.
3 Place the shredder unit back onto the waste basket.
Important: The shredder unit should be placed correctly, or the shredder
will not work.
Important: If the shredder has been used while the waste basket was full,
the shredder may generate extra noise because of paper scraps
adhering to the cutter blades. You can disregard the noise, because the
shredder’s operation is not adversely affected.
Specifications
• Cut type: cross cut
• Crosscut piece size (mm) 0.16 × 1.81 inches (4 × 46 mm)
• Shred capacity (20 lb. bond) 7 sheets
• Entry width: 9.06 inches (230 mm)
• Shredder dimensions: 12.68 Ч 7.48 Ч 14.96 inches
(322 Ч 190 Ч 380 mm)
• Rated voltage and frequency: 120V~60 Hz
• Rated current: 3A
Copyright
© 2007 Dynex. DYNEX and the DYNEX logo are trademarks of Best Buy
Enterprise Services, Inc. Other brands and product names are trademarks
or registered trademarks of their respective holders. Specifications and
features are subject to change without notice or obligation.
For service and support call (800) 305-2204.
Handle
Handle
Clear
window
DX-OP7CC.fm Page 3 Saturday, January 6, 2007 11:24 AM