Drolet SIT 0.820.634 - Manual (Page 18)

ULTRA FLAME DIRECT VENT GAS STOVE 17
Logs Installation
1. Remove the front glass.
2. Locate the log grate in the retainers in the right
and left rear corners.
3. Place the rear log (1) against the rear log stop.
Make sure grooves under the log line up with the
grate.
4. Place logs 2 and 3 against the stops in the middle
of the grate. Again see that grooves in the bottom
of the logs line up with the grate.
5. Place log 4 into the grooves of logs 1 and 2.
6. Log 5 sits over log 1 and 3.
7. Put the glass front assembly back in place.
Ember Kit Installation
CAUTION: Blocking gas ports with rock wool will result in poor light-up performance and delayed
ignition.
1. Place some pieces of rock wool fibers approximately 1/2" large behind the front gas ports.
2. Never put too much of rock wool on the gas ports. The gas must pass through the burner easily.
3. Cover entirely the first row of the front gas ports. You may have more than one piece thick over the same
gas port.
4. Light the stove. Modify the configuration of the rock wool on the gas ports until you reach the desired
effect.
5. Make sure not to put too many pieces as this could result in an altered flame pattern and possible carbon
deposition on the logs.
Bay Window Installation
Installation
• Put the front glass assembly back in position.
• Insert the hooks of all four clamps in the glass
front slots.
• Tighten both top clamps simultaneously.
• Tighten both bottom clamps simultaneously.
• Close the side panels and install both decorative
trim pieces.
Un-installation
• Let the stove cool down for at least one hour.
• Open both side panels.
• Open the four clamps.
• Remove the front glass assembly.
CAUTION: Do not operate your stove without bay window or with broken glass.