Cybex 18030 Bravo Lift - Manual (Page 11)

11
Cybex Owner’s Manual
If Then
18030 cannot fit
through doorway
1. Move pulley and cable connection out of the way.
2. Remove guide rod caps. Guide rod cap contains a compression
spring that will fly if grasp is not released slowly. Slide spring loaded
guide rod cap down guide rod until cap is clear of frame. Slowly
release grasp of guide rod cap and remove.
3. Remove lifting post.
4. Remove weight plates.
Move handle, pulley, and cable
1. Remove the pin spring with a 3/16” punch and hammer securing
handle to ball stop and remove handle.
Pin Spring BHSCS/Ball Stop
Handle
2. Remove the two Button Head Socket Head Cap Screws (BHSCS)
securing the ball stop together with a 1/8”Allen wrench.
3. Remove the BHSCS and locknut securing the pulley using a 7/32”
Allen wrench and a 9/16” wrench.
BHSCS/
Locknut
Pulley
4. Move pulley and cable out of the way.
5. Repeat steps above for opposite handle, ball stop, pulley and
cable.