Cybex 11020 Eagle Incline Pull - Manual (Page 11)

11
Cybex Owner’s Manual
14. Attach pulley shaft using the pivot shaft and BHSCS.
BHSCS
Pivot Shaft
Washer
Pulley Shaft
Pulley/Cable
15. Reconnect pulley/cable to pulley bracket.
16. Verify both cables are routed properly.
17. Connect the weight stack belt to the belt clamp of cam.
Set
Screws
Cam
Install rubber feet
1. Remove each (standard) cone-shaped shipping support using a 3/4” socket or wrench.
2. Cut shipping tie securing top weight.
3. Place rubber feet (supplied with machine) on each foot of the frame.
4. Lift top weight and turn the Increment Weight Adjusting Knob to select 15 lbs (three
increment weights each side.)
5. Remove the three Phillips head screws securing the top (back) shroud and carefully remove
the shroud.
Phillips Head
Screw (3)