Cybex 11030 Eagle Row User Manual
Page 12
12
Cybex Owner’s Manual
3. Place rubber feet (supplied with machine) on each foot of the frame.
4. Lift top weight and turn the Increment Weight Adjusting Knob to select 15 lbs. (three
increment weights each side.)
5. Remove the three Phillips head screws securing the top (back) shroud and carefully remove
the shroud.
Phillips Head
Screw (3)
6. Loosen but do not remove bottom two screws.
Screw (loosen -
do not remove)
7. Remove the top two screws securing the back shroud.
Screw
8. Slide rear shroud assembly upward and remove.
Install the weight stack
1. Note how the increment weights are installed.
2. With an assistant holding the increment weights, move the adjusting knob to 0 lbs and
remove all six increment weights (three each side.)
3. Using an external snap ring pliers, remove the upper snap ring from one of the guide rods
and carefully lower the guide rod.
Upper snap ring
Lower snap ring
Frame
Guide rod
Wave washer