Operating fireplace, Installation – Desa CGEFP33PRB User Manual

Page 25

Advertising
background image

www.desatech.com

111245-01B

25

Figure 44 - Installing Crossover

Logs (#4 & #5) [CGEFP Logs Shown]

Pins

Crossover
Log (#5)

Crossover
Log (#4)

INSTALLING BATTERY INTO
REMOTE

1. Locate slot at bottom of remote control (see

Figure 45). Firmly insert tool such as a small

screwdriver, butter knife or dime into the slot

and lift up to remove cover.

2. Insert supplied battery into remote control.

Positive and negative are marked inside re-

mote control casing. Note: Remote will not

function if battery is not installed correctly.

3. Slide tab on cover into remote housing and

snap cover back into place.

IMPORTANT:

Use only A23 12 volt battery in

remote. DO NOT use AAA battery.

Positive

Figure 45 - Installing Battery

Negative

Tab

Cover

Remote
Control

Slot

A23 12
Volt Battery

Figure 46 - Installing Fireplace Screen

INSTALLING SCREEN

Install fireplace screen by slipping notches of

fireplace screen over screws on front of fireplace

(see Figure 46).

Notches

Screws for

Mounting

Screen

INSTALLATION

Continued

OPERATING FIREPLACE

FOR YOUR SAFETY

READ BEFORE LIGHTING

WARNING: If you do not fol-

low these instructions exactly,

a fire or explosion may result

causing property damage, per-

sonal injury or loss of life.

A. This appliance has a pilot which lights auto-

matically when using the supplied wall switch

or remote control. If you have a power outage,

the pilot may be lighted by hand with push-

button piezo ignitor. When lighting the pilot,

the following warnings must be followed.

B. BEFORE LIGHTING smell all around the

appliance area for gas. Be sure to smell next

to the floor because some gas is heavier than

air and will settle on the floor.

WHAT TO DO IF YOU SMELL GAS

• Do not try to light any appliance.

• Do not touch any electric switch; do not

use any phone in your building.

• Immediately call your gas supplier from

a neighborʼs phone. Follow the gas

supplierʼs instructions.

• If you cannot reach your gas supplier, call

the fire department.

C.

Electric Power Outage Only:

Use only your

hand to turn the manual override handle

on the gas control knob. Never use tools. If

the knob will not turn by hand, donʼt try to

repair it, call a qualified service technician

or gas supplier. Force or attempted repair

may result in a fire or explosion.

D. Do not use this appliance if any part has been

under water. Immediately call a qualified

service technician to inspect the appliance and

to replace any part of the control system and

any gas control which has been under water.

Advertising
This manual is related to the following products: