Dimplex HFPI9280 - Manual (Page 11)

9
HFPI9280, DFPI2311
If the unit was operating prior to servicing allow at least 10 minutes for light bulbs and
heating element to cool off to avoid accidental burning of skin.
Disconnect power before attempting any maintenance or cleaning to reduce the risk of
electric shock or damage to persons.
TO REPLACE MANUAL CONTROL ON/OFF SWITCH
1. Remove the glass doors and trim from the unit and remove it from the opening.
2. Unscrew the screws located in the middle of the top and the two screws at the back of
the top.
3. Remove the top being careful not to damage any of the attached wiring.
4. Disconnect the wiring switch harness from the circuit board by gently pulling.
5. Locate and remove the manual control on/off switch located in the front corner of the
unit by depressing the retainer clips on the rear of the switch and pushing the switch
out of the front of the unit.
6. Properly orientate the new switch and connect all of the wiring clips and
connections.
7. Reassemble in the reverse order as above.