Dodge 2008 Ram Pickup 1500 User Manual

Page 337

Advertising
background image

ESP Partial Off
This mode is entered by momentarily depressing the

ЉESP OFF” switch. When in ЉPartial OffЉ mode, the TCS
portion of ESP, except for the “limited slip” feature
described in the TCS section, has been disabled and the

ЉESP/TCS Indicator LightЉ will be illuminated. All other
stability features of ESP function normally. This mode is
intended to be used if the vehicle is in deep snow, sand,
or gravel conditions and more wheel spin than ESP
would normally allow is required to gain traction. To
turn ESP on again, momentarily depress the

ЉESP OFF”

switch. This will restore the normal “ESP On” mode of
operation.

NOTE:

To improve the vehicle’s traction when driving

with snow chains, or starting off in deep snow, sand or
gravel, it may be desirable to switch to the “Partial Off”
mode by pressing the ESP switch. Once the situation
requiring ESP to be switched to the “Partial Off” mode is

overcome, turn ESP back on by momentarily depressing
the “ESP Control Switch”. This may be done while the
vehicle is in motion.

WARNING!

In the Partial Off mode, the engine torque reduction
and stability features are desensitized. Therefore, the
enhanced vehicle stability offered by ESP is
unavailable.

All 4WD vehicles in Auto and 4HI Modes can also
choose the following ESP operating mode. This is
the only ESP operating mode in 4LO:

Full Off
This mode is intended for off-road use when ESP stability
features could inhibit vehicle maneuverability due to trail
conditions. This mode is entered by depressing and

STARTING AND OPERATING

335

5

Advertising