Cybex 16110 Plate Loaded Leg Press - Manual (Page 11)

11
Cybex Owner’s Manual
Install weight tubes
1. Remove one bearing sleeve.
2. Insert weight tube through frame.
Frame
Bearing Sleeve
Weight Tube
3. Verify outside length of weight tube measures 9.5 inches.
9.5”
Set Screw (2)
Frame
Weight
Tube
Bearing Sleeve
Bearing Sleeve
4. Secure tube in place with set screws located on both sides of frame, using a 1/8” Allen wrench.
(see above diagram.)
5. Repeat above procedure for opposite weight tube.
Securely anchor machine to the floor
Cybex strongly recommends to maximize stability, equipment must be secured to a solid level
surface.
WARNING: Anchoring equipment:
• Cybex is not responsible for the actual anchoring of equipment. Consult with a
professional contractor.
• Use fasteners having a minimum of 500 lbs. tensile capacity (3/8’’ grade 2 bolts or
better).
• If legs/frame does not contact surface, DO NOT pull down with anchors. Shim
any leg or frame not in contact with surface using flat washers.
Verify proper operations