D.T. Systems R.A.P.T. 1400 Series - Manual (Page 13)

13
TURNING ON AND OFF
The Transmitter is always in a permanent sleep state.
It is only ON when a button is being pressed and does
not need to be turned off by the user. If the
Transmitter does not activate, make sure you have a
good battery installed and that your Collar Selector
Dial is not in the Lockout position.
Turning the Collar Unit ON/OFF:
Turning the Collar Unit ON and OFF uses the same
procedure:
1. Hold the Transmitter Magnet Indicator (white dot)
directly against the Magnetic Activation Switch
(small bump) on the right side of the Collar Unit.
2. The SmartLED Indicator will light solid for a
second and then start flashing. Remove the
Transmitter from the Collar Unit when the
SmartLED light begins to flash.
If the Collar Unit has been turned ON, the SmartLED
will flash approximately every other second. If the
Collar Unit has been turned OFF, the SmartLED will
no longer be flashing.
NOTE
If the LED on the Transmitter flashes red rapidly after any
button is pressed, the 9V battery will need to be replaced.
If the SmartLED on the Collar Unit double-flashes red every
other second while ON, the unit will need to be recharged.
If this happens soon after a full charging session, the re-
chargeable batteries in the Collar Unit may need to be re-
placed.