Daktronics DA-1000 Outdoor Decorative Accent - Manual (Page 12)

6 Installation
5. Slide a lock washer, flat washer, and I-beam clamp onto each bolt, and loosely screw
the bolts into the spring nuts.
6. Position each I-beam clamp assembly as close to the I-beam flanges as possible.
7. Make final adjustments in the positioning of the accent to ensure it is flush and level,
and firmly tighten all of the bolts (Figure 6).
8. Repeat steps 2-7 for the other mounting hardware set on the bottom rear of the accent.
9. Repeat step 8 for all beams.
10. Remove the lift eyebolts and fill remaining holes with silicone.
1) Insert into channel 2) Twist Correct spring nut position
Figure 5: Spring Nut Insertion
Figure 6: Accent Mounting with I-beam Clamps, Rear Isometric View
1
2