Daktronics Galaxy AF-3400 20 mm Monochrome/RGB Double-face Displays - Manual (Page 33)

Start-up Procedure
25
Section 5: Start-up Procedure
Before starting up the display, go over this checklist to ensure that all parts are ready to operate
correctly. Figure 26 shows the basic display components referred to in each step.
5.1 Start-up Checklist
D
Is power connected to the display?
The power conduit will leave the display from the right end of Face A and connect to a
power source either on the display structure or inside a building. Refer to Figure 26 for
approximate location of the power cable or conduit.
D
Is the control computer connected to the display?
Some type of communication line or wireless device will send signal between the control
computer and the display, depending on the communication method. Refer to Section 4 for
assistance with identifying the communication type.
D
Is the computer software set up to work with the display?
The software manual provides the information necessary to allow the computer to
communicate with this display. Consult the software manual's Configuration section for
correct set-up.
Figure 26: Basic Display Set-up