Design Dynamics VTD-24N-JHB - Manual (Page 5)

www.desatech.com 114370-01E 5
PRODUCT IDENTIFICATION
Figure 1 - Product Identification (Ramp
Pan Burner)
Log.Set
Assembly
Grate
Chassis
INSTALLATION
WARNING: Before installing
in a solid fuel burning fireplace,
the chimney flue and firebox
must be cleaned of soot, creo-
sote, ashes and loose paint by a
qualified chimney cleaner. Creo-
sote will ignite if highly heated. A
dirty chimney flue may create and
distribute soot within the house.
Inspect chimney flue for damage.
If damaged, repair flue damper
before operating appliance.
NOTICE: Installation, service and
repair of this appliance must be
performed by a qualified installer,
service agency, company or
gas supplier experienced with
this type of gas appliance. Only
factory authorized components
listed in these instructions may
be used in accordance with the
manufacturer's instructions and
all codes and requirements of
the authority having jurisdiction.
Any modifications to or use of
unauthorized components or
accessory items will void the
manufacturer’s warranty and may
result in a hazardous condition.
Ceramic.
Burner
WARNING: Failure to posi-
tion the parts in accordance
with these diagrams or failure
to use only parts specifically
approved with this appliance
may result in property damage
or personal injury.
CHECK GAS TYPE
Use.only.natural.gas..If.your.gas.supply.is.not.
natural gas, DO NOT install this gas log set.
If the fireplace does not have a gas supply
shutoff valve, one must be installed.
WARNING: This appliance is
equipped for natural gas. Field
conversion is not permitted.
FLUE OPENING SPECIFICATIONS
Note: This vented appliance must be installed
only in a solid-fuel burning fireplace con-
structed of noncombustible material.
The charts in Figure 2, page 6 indicate tech-
nical.information.regarding.the.installation.of.
your.gas.log.set..Please.make.sure.that.all.of.
the specifications shown are applicable before
installation.is.attempted..
The fireplace must include a flue and venting
system with the minimum openings shown in
Figure 2, page 6.