Daktronics AF-3010-34 - Manual (Page 30)

RS422
One end of the signal cable should be terminated to the surge suppressor terminal
block in the display labeled “IN RS422” (TB1). Drawing A-88427 is an example of
the termination panel. The opposite end is terminated at the signal converter
(Daktronics part number 0A-1127-0237). Refer to Drawing A-92681 shows an
example system riser using the RS422 signal termination.
Figure 19: RS422 Signal Converter Connections
Signal Converter (J4/J5) Field Cabling Terminal Block (Data In)
Pin 1 (GND) Red Pin 1 (GND)
Pin 2 (RX-P) Black Pin 2 (TX-P)
Pin 3 (RX-N) Brown Pin 3 (TX-N)
Pin 4 (TX-P) White Pin 4 (RX-P)
Pin 5 (TX-N) Blue Pin 5 (RX-N)
Green Pin 6 (GND)
Pin 6 (GND)
Shield (Bare) N.C.
Electrical Installation 3-8