Daktronics CE-1010 - Manual (Page 25)

Maintenance and Troubleshooting 4-7
Entire display is garbled or a
section of the display is bad. • Power down, then power up the display.
Section of the display network is
not working. • Bad input on the first bad display.
• Bad output on the last good display.
• Switch the suspect display with a known good display.
Note: The display configuration is shown on operation and contains the following
information:
1. Positions (x=1, y=1)
2. Firmware Version
3. Size 4x8
4. COM1 Configuration (DataView
™
19200)
5. COM2 Configuration (DataView ™ 9600)
6. Display Address—displayed in binary code (i.e. 001)
7. Modem (if present)
4.5 Replacement Parts
Common Parts
Part Description Part Number
DataTrac CE-1010 Display Manual ED11477
Signal Converter- 120 VAC 0A-1127-0255
Signal Converter- 240 VAC 0A-1127-0250
Serial Cable W-1249
Adapter DB9M to DB25F A-1603
Patch Cable, 10ft, RJ45, 4 Pair Twisted W-1383
Network Tester 0A-1146-0005
Display Interconnect Cable 0A-1120-0176
Power Cord, 120VAC W-1181
Cable, 18” RJ11 6-cond straight 0A-1137-0160
Cable; 25” RJ11 6-cond straight W-1265
Cable, 36” RJ11 6-cond straight 0A-1120-0134
Cable, 100” RJ11 6-cond straight 0A-1146-0002
Cable; 500” RJ11 6-cond straight 0A-1146-0003
Cable Assy; 40 Pos 8” W-1341
Cable Assy; 40 Pos 18” W-1362
Cable Assy; 40 Pos 36” 0A-1000-0006
Power Supply; 5V @10A A-1568
Power Supply; 6.5V @15A A-1591
1.2” Display
Controller- 422 DVIEW 0A-1120-0135
Controller- 422 V1500 0A-1120-0016
Module; CE-10**-4x6-1.2-RG 0P-1120-0030
Panel; CE-1010-4x6-1.2-RG-Flush 0A-1120-0514
Panel; CE-1010-4x6-1.2-RG-Flush 0A-1120-0515
2.1” Display
Controller- 422 DVIEW 0A-1120-0135