Daktronics Pro Series Quick Start Manual - Manual (Page 4)

i-Batten Safety Feature
When enabled, if a change in batten weight
is detected, the motor will stop until weight is
returned to normal. If disaled, this icon has
a red slash over it.
M
AN
U
AL
Move Motor Auto
Touch AUTO UP/DOWN.
Select a target (upper,
lower or one of three
alternates) by touching
and holding its button
for three seconds. The
motor will then move to
its target.
Move Motor Manually
Touch and hold the arrow
buttons. Slide your finger
to minus (-) to slow the
speed or plus (+) to
increase it. The motor will
stop when the button is
released or when the
motor has reached
its limit.
Change Icon
Touch the icon button twice to
display the Icon Selection
panel. Touch category to
display icons. Touch icon to
select. Touch DONE to confirm.
Change
Speed
Drag the
button left or right. Touch
the button twice to manually
enter the speed.
MANUAL
The Manual module
allows all users the
ability to control
motors and to
work with targets.
Targets are the upper
and lower positions
that the motor will
be moving to most
of the time.
This module allows
the setting and
clearing of targets.
Clear Targets
Touch the yellow buttons to clear
an alternate target, blue to clear
the upper target or green to clear
the lower target. The button will
change to read CONFIRM. Touch
again to clear the target.
Set Targets
Touch SET TARGETS. From the menu, pick which target (upper,
lower or one of three alternates) to change. The keypad will display
the boundaries. Enter the target numerically or use current batten
position. To change multiple targets, select them from the menu and
make the changes before touching CONTINUE.
Motor Info
Touch this button to see detailed information
screens (above) about the selected motor.
Change Motor
Touch the button
under Motor Select
to display the list
of motors. Touch a
motor name to select.
Touch CONFIRM.
Move Motor To
Position
Touch MOVE TO
POSITION. Enter target
in keypad, set speed and
touch MOVE. The motor
will then
move to
its target.
Batten Position Indicator
Shows Upper, Lower and Alternate Targets