Delta Electronics Pulse Generator Card PG-03 - Manual (Page 3)

3
PG-03 Terminal Descriptions
Terminals
Terminal Symbols Descriptions
+12V
Power Supply of the Encoder: +12V
Output Voltage: +12V
±5% 200mA
0V Common point for the power supply and the signal
Encoder signal input (select the output type of the Encoder from FSW2)
Both single-phase input and two-phase input available
Maximum: 500KP/Sec
A/O, B/O
The Encoder signal output
Maximum: DC24V 50mA
Common point for signal grounding
Wiring Notes
1. Please use a shield cable to prevent interference. Do not run control wire parallel to any high
voltage AC power line (220 V and up).
2. Connect shielded wire to E only.
3. Recommended wire size 0.21 to 0.81mm 2 (AWG24 to AWG18).
4. Wire length:
The Output Types of the
Encoder
Maximum Wire
Length
Wire Gauge
Output Voltage 50m
Open Collector 50m
Line Driver 300m
Complementary 70m
1.25mm 2 (AWG16) or above