DFI CD9A3 series - Manual (Page 21)

www.dfi.com Chapter 3 Hardware Installation
21
Chapter 3
Standby Power LED
Standby
Power LED
This LED will light when the system is in the standby mode.
Cooling Option
Heat Sink with Cooling Fan
• “1” and “3” denote the locations of the thermal pads designed to contact
the corresponding components that are on CD9A3 Series.
Top View of the Heat Sink
Important:
Remove the plastic covering from the thermal pads prior to mounting the heat sink
onto CD9A3 Series.
Note:
The system board used in the following illustrations may not resemble the actual
board. These illustrations are for reference only.
Bottom View of the Heat Sink
1 2