DFI COM630-B - Manual (Page 24)

24
2
Hardware Installation
Front Audio
The front audio connector allows you to connect to the line-out and mic-in jacks
that are at the front panel of your system. Using the line-out and mic-in jacks
will disable the rear audio’s line-out and mic-in functions. Remove the jumper
caps from pins 5-6 and pins 9-10 prior to connecting the front audio cable con-
nector. Make sure pin 1 of the cable is aligned with pin 1 of the connector. If you
are not using this connector, make sure to replace the jumper caps back to their
original pin locations.
Pins 5-6 and 9-10 short (default)
Pins 5-6 and 9-10 open
The front audio is disabled.
The rear audio is enabled.
The front audio is enabled.
The rear audio is disabled.