Diamondback Fitness 510Ub - Manual (Page 11)

510Ub Owner’s Manual
11
19. Remove the five (5) hex bolts (C‐
6), four (4) flat washers (C‐7) and
one (1) curved washer (C‐8) from
the main frame and set aside.
20. Orient and slide the console mast
cover (D‐2) upward onto the
console mast (C) and hold in
place, half the way up the mast.
21. While supporting the console
mast, carefully join connectors
(C‐15 and D‐1). Make sure the
connection is complete.
22. Slide the console mast (C) into
place onto the main frame (taking
care to not damage the cables).
23. Install the two (2) bolt and flat
washer assemblies (C‐6 & C‐7)
through the lower holes on each
side of the console mast and into
the frame. Tighten firmly.
24. Re‐install hex bolt and curved
washer assembly (C‐6 & C‐8) into
the front of the console mast.
Tighten firmly.
25. Slide the console mast cover (D‐2)
downward and snap into place.
26. Re‐install the two (2) hex bolt and
flat washer assemblies (C‐6 & C‐7)
into upper holes in the sides of
the console mast.