Fog lights — if equipped, Turn signals, Highbeam/lowbeam select switch – Dodge 2006 Charger User Manual

Page 103: Flash to pass

Advertising
background image

Fog Lights — If Equipped

The front fog light switch is on the headlight
switch below the dimmer control. To activate the
front fog lights, turn on the parking lights or the

low beam headlights and press the fog light switch.

NOTE:

The fog lights will operate with the low beam

headlights, or parking lights on. However, selecting the
high beam headlights will turn off the fog lights.

Turn Signals

Move the Multi-Function Lever up or down and the
arrows on each side of the instrument cluster flash to
show proper operation of the front and rear turn signal
lights. You can signal a lane change by moving the lever
partially up or down without moving beyond the detent.
Releasing the lever at the detent will provide 3 flashes.

If either light has a very fast flash rate, check for a
defective outside light bulb. If an indicator fails to light
when the lever is moved, it would suggest that the fuse
or indicator is defective or there may be a circuit failure.

NOTE:

The message “Turn Signal On” will appear in

the electronic vehicle information center (EVIC) — if
equipped, and a continuous chime will be heard when
the vehicle has been driven more than 1 mile (1.6 km)
with either turn signal on.

Highbeam/Lowbeam Select Switch

Push the Multi-Function Lever away from you to switch
the headlights to HIGH beam. Pull the Lever towards
you to switch the headlights back to LOW beam.

Flash to Pass

You can signal another vehicle with your headlights by
lightly pulling the Multi-Function Lever toward you.
This will cause the headlights to turn on at high beam
and remain on until the lever is released.

UNDERSTANDING THE FEATURES OF YOUR VEHICLE

103

3

Advertising
This manual is related to the following products: