Dynex DX-DPF7-10 - Manual

Quick Setup Guide
DX-DPF7-10 7" Digital Picture Frame
Features
Top view Side views
Package contents
• Digital picture frame
• AC adapter
• Remote control
• User Guide
• Quick Setup Guide
Connecting the AC adapter
1 Complete all other connections.
2 Plug the small AC power connector into the DC 5V jack on the side
of your digital picture frame, then plug the other end into an AC
power
outlet.
Installing the remote control battery
NOTE: A battery comes pre-installed in your remote control. To activate the battery, remove the plastic shipping tab
from the battery tray.
WARNING: There is a danger of explosion if the battery is not replaced correctly. Replace with the same or equivalent
type battery.
1 Turn the remote control over to the back side.
2 Push the release tab to the right and pull the battery tray out of the remote control.
3 If this is the first time you will be using the remote control, remove the plastic shipping tab that covers the battery.
-OR-
If you are replacing the battery, remove the old battery and insert a new lithium coin cell battery (CR2025) into
the battery tray. Make sure that you match the + symbol on the battery with the + symbol on the battery tray.
4 Slide the battery tray back into the remote control until it clicks into place.
Power
Left
arrow
Exit
Right
arrow Rotate
Copy/
Delete Mode/Enter
USB port
DC 5V jack
Memory card slot
Step 2 Step 3 Step 4
Positioning your digital picture frame
Your digital picture frame has a built-in stand. The stand can be
rotated to support the frame in either a horizontal or a vertical
position. Make sure that the stand is rotated to a position
indicated on the back of the frame in order to ensure stability.
Your frame can also be wall-mounted. Please use the slots on
the back of the frame for either horizontal or vertical mounting.
NOTE: Hardware for mounting your frame is not included.