Digi-Star SW3300 - Manual (Page 12)

11
Extension tube may be cut down to provide a custom scale width. Simply re-drill the
mounting cross-hole after cutting down the pipe on one end.
Wires and cables must be stowed and secured safely to prevent damage. Secure all
cables of off ground and away from animals with nylon cable ties or other fasteners.
Maintenance:
There are no moving parts and no lubrication required. The only maintenance required
is periodic cleaning of the mounts and the area below the scale to assure free and
unencumbered operation of the scale. If a pressure washer is being used, do not spray
or direct high pressure stream at the load cells. Load cell damage may occur.
Stand over each of the 4 corners to troubleshoot for problems. Corners should weigh
the same within ±2 display counts. Scale system accuracy is ±1% maximum error.
Do not weld to load cells with load cell cables connected to the indicator. If you must
weld with load cells connected, locate welder ground so that current will not flow
through the load cell.
Important
Assembly Diagram 14k Load Cells
NOTE PROPER
ORIENTATION