DNF Controls DMAT-DL - Manual (Page 5)

5 DMAT, for DoReMi Labs Protocol
4. SETUP MENU
Press [MENU]. The MENU key indicator will turn on.
Turn the Wheel to select item to change.
Press [MENU] OR use the Softkeys to change the desired mode for that option.
Turn the Wheel at any time to select another item.
Press [ESC] at any time to exit SETUP MENU. The MENU key indicator will turn off.
MODES: (Turning Wheel clockwise)
RECORD Press
[MENU] to select the desired record mode:
Lockout, Assemble, Crash (Full) or Insert.
Only in INSERT mode: Press the associated Softkey, located below the
display, to toggle Video(V), Audio1(A1), Audio2(A2), Audio3(A3),
Audio4(A4) on/off.
MARK-Q
Press Softkey to:
Enable ADVANCE to next Cue Point, when [MARK] is pressed.
OR
Maintain CURRENT Cue Point when [MARK] is pressed.
WIND
Press Softkey to select:
MODE HOLD
(Fast wind is maintained only while key is pressed.)
OR
LATCH
(Fast wind is initiated and maintained with momentary key press.)
Select fast wind speed (3.9 to 23.7) by pressing Softkey below SPD.
SLOMO
ST300 display shows:
Press Softkey [TBAR] (or [WHEEL]) to toggle between them.
The T-BAR has two speed ranges:
0Î+200 with a detent at +100% play speed
OR
0Î+100 with a detent at +100
For Wheel only:
Press Softkey [SPEED] to select SLOMO speed ranges:
Press Softkey to select: 0 Æ +200 OR -100 Æ +200.
Press Softkey [BACK] to return to SLOMO MENU.
Press the [ESC] key to exit SETUP MENU.
SLOMO with: WHEEL
TBAR Speed Prset